Dometic RM 3662 - Certified Installation Requirements; Installation Clearances

'96 TIS 46 141 238393
HO
CERTIFIED INSTALLATION
Certified installations require one roof vent and one
lower side vent.
For "Certified Vent System Kits” see page 15.
For further information contact your dealer or distributor.
NOTE: The upper vent should be
centered over the condenser coil
at the beck of the refrigerator.
I
I
I
Minimum 1
ventilation ,
FIG. 9
METHODS OF INSTALLATION
The method of installation is shown in FlG. 9. It is
essential that all maximum or minimum dimensions are
strictly maintained as the performance
of the refrigerator
is dependent on adequate flow of air over the rear of the
refrigerator,
VENTILATION HEIGHTS
r Installation with roof
Minimum ventilation
vent and tower side vent
heights
in
Refrigerator
RM3662, RM 3663
Inches
mm
57-3/4 1465
NOTE: Wood Strip
MUST be in place.
CLEARANCE%
Minimum clearances In inches to combustible materials
are:
G: Top 0
K: Slde 0
L: Bottom 0
M: Rear 0
N:
See NOTE: Clearance "N” below.
NOTE: Clearance
“M” is between the rearmost part of
the refrigerator and the wall behind the refrigerator.
NOTE:
Clearance “N" is the distance between the bot-
tom of the lower vent to the roof material. For ventilation
height,
see table VENTILATION HEIGHTS
See Figures 9, and 10.
RM 3662; RM 3963
1 63-3/4 1620