EasyManuals Logo

Dometic RM 5330 Installation Manual

Dometic RM 5330
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
EN
RM5310, RM5330, RM5380 Installing the refrigerator
77
6 Installing the refrigerator
6.1 Preparing for installation
When installing the refrigerator, note the following:
For the coolant to circulate properly, the refrigerator may not exceed an
incline of 3°.
To check this, park the vehicle in a horizontal position and check whether
the ice tray is level in the refrigerator.
The refrigerator must be installed in such a way that it is easily accessible
for service work, can be removed and installed easily, and can be
removed from the vehicle without major effort.
The distance between the refrigerator and the back wall must total at least
15 mm.
The refrigerator must be installed in a recess to prevent it from moving
when the vehicle moves. Observe the following relevant dimensions
(hxwxd in mm):
RM5310: 618 x 486 x 474, fig. 1, page 3
RM5330: 821 x 486 x 474, fig. 2, page 3
RM5380: 821 x 486 x 474, fig. 3, page 3
Provide an air inlet (fig. 4 1, page 4) and an air outlet (fig. 4 2, page 4)
with ventilation grilles in the exterior wall to allow generated heat to be dis-
sipated to the outside:
Air inlet: The ventilation grille should be as flush as possible with the
floor of the installation recess and have a cross-section of at least
250 cm².
Air outlet: preferably above the device It is also possible to use a
ventilation grille with integrated exhaust gas routing.
If the ventilation grille of the air inlet cannot be installed flush with the floor,
an additional air inlet (fig. 4 4, page 4) must be provided on the ground
to discharge escaping gas.
The air inlet and air outlet may not be covered by parts of the vehicle
during operation (e.g. by an open door or by attached accessories such
as bicycle racks).
If the distance between the structure door and the air outlet is
25 mm 45 mm, install an installation kit (see chapter “Accessories” on
page 76).
There must be enough space on the back of the refrigerator to let the air
circulate around the cooling element.

Other manuals for Dometic RM 5330

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dometic RM 5330 and is the answer not in the manual?

Dometic RM 5330 Specifications

General IconGeneral
Noise level- dB
Climate classSN
Total net capacity65 L
Total gross capacity70 L
Lamp typeLED
No Frost (fridge)-
Fridge net capacity60 L
Fridge interior lightYes
Door hingeLeft
Product colorBlack, Grey
Appliance placementFreestanding
Refrigerating mediumR717
Freezer positionTop-placed
Freezing capacity- kg/24h
Freezer net capacity5 L
Storage time during power failure- h
Current0.54 A
Power sourceGas/Electric
Connected load125 W
Gas consumption270 g/24h
AC input voltage230 - 240 V
AC input frequency50 - 60 Hz
Package depth543 mm
Package width523 mm
Package height845 mm
Package weight27000 g
Weight and Dimensions IconWeight and Dimensions
Depth474 mm
Width486 mm
Height821 mm
Weight22000 g

Related product manuals