8
NOTE: DO NOT continue to reset GAS operation if the CHECK indicator lamp continues to be
illuminated after several tries.
Press the TEMPERATURE SELECTOR button (4) until the lamp (F) at the desired position is illuminated.
The temperature selector on the refrigerator controls both the gas and electric operation, thereby
eliminating the necessity of resetting each time a different energy source is employed.
After the initial start-up, the temperature selector should be moved from "COLDEST" to the desired
temperature setting, which is usually about mid-setting.
TO SHUT OFF THE REFRIGERATOR
The refrigerator may be shut off while in any mode of operation by pressing the main power ON/OFF button
(1) to the UP (OFF) position. This shuts off all DC power to the refrigerator, including the interior light.
DC MODE (3-WAY MODEL ONLY)
Press the DC mode indicator button (2) to the DOWN position. (Lamp [A] will light).
Press the TEMPERATURE SELECTOR button (4) until the lamp (F) at the desired position is illuminated.
The refrigerator will continue to operate in the DC mode until switch (2) is moved to the UP position.
Turn off the refrigerator or move the DC selector button (2) to the UP/OFF position. The DC mode
overrides all the other operating modes. Discharging of the battery will occur if the vehicle engine
is not running.
TEMPERATURE SELECTOR
ELITE REFRIGERATOR OPERATION (2-WAY)
MODELS INCLUDE: RM4872
2-WAY DISPLAY PANEL
ON
OFF
AUTO
AC GAS
1
2
CHECK COLD 1 2 3 4 5 COLDEST
3
B
C
A E
D
AUTO MODE
Press the Auto mode selector button (2) to the DOWN position. Lamp (B) will illuminate. If 120 volts is
available, the AC mode indicator lamp (A) will illuminate indicating AC operation. If 120 Volts AC is not
available, the GAS indicator lamp (C) will illuminate, indicating the control has automatically switched to
the GAS mode.
If the CHECK indicator lamp (D) illuminates and the GAS mode indicator lamp (C) is off, the controls have
failed to ignite the burner in the GAS mode. GAS operation may be reset by pressing the main power
ON/OFF button (1) to the OFF then ON position. (See Step 2 under GAS MODE). Press the
TEMPERATURE SELECTOR button (3) until the lamp at the desired position is illuminated.
Manual Compliments of
Northwest RV Supply
Printed From
http://www.nwrvsupply.com
To Next Page
Loading...
Need help?
General
