RM5310 – RM5385 Troubleshooting
27
Displayed faults and signal tone (RM5385 only)
Faults are indicated by the flashing of individual buttons on the control panel,
a beep or a combination of both.
Display Problem Suggested remedy
and flashing,
a beep is emitted for
20 seconds
The AC heating
element is defective.
Contact the authorised
customer service.
and flashing,
a beep is emitted for
20 seconds
The DC heating
element is defective.
and flashing,
a beep is emitted for
20 seconds
The burner or the
cooling unit is
defective.
flashes
The temperature
sensor has no contact
or is defective.
and flashing,
a beep is emitted for
20 seconds
The power supply
is not available or
insufficient.
Check the AC power cable, the
power supply and the fuse.
and flashing,
a beep is emitted for
20 seconds
The power supply
is not available or
insufficient.
Check the DC power cable, the
vehicle battery and the fuse.
Check the D+ signal on the
vehicle.
and flashing,
a beep is emitted for
20 seconds
The burner flame is
not ignited.
Check the gas supply (gas
cylinder, gas valve).
Press the button once the
fault is rectified.
Beep is emitted for
15 seconds at intervals
of two minutes
The interior light is
switched on.
Check whether the refrigerator
door is properly closed.
Close the refrigerator door.
To Next Page
Loading...
