Installing the refrigerator RMD10
20
➤ Seal the installation frame to make the connection waterproof (fig. 0, page 8).
➤ Insert the installation frame and screw it down tightly (fig. a, page 8). Use all the
fixing holes for this.
➤ Insert the ventilation grill as shown (fig. b, page 8).
4.5 Installing condensation drain
I
Install the condensation drain as follows:
Variant 1
➤ Run the condensation hose from the refrigerator through an opening in the floor
which goes outside under the vehicle.
Variant 2
➤ Attach the condensation hose directly to the fitting intended for it on the
ventilation grill (fig. 9 4, page 7).
4.6 Install the roof vent
➤ Seal the installation frame to make the connection waterproof (fig. d, page 8).
3 Installation frame
4 Fastening for condensation drain
NOTE
• Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
• Condensation must be drained with a constant slope.
No. in
fig. c, page 8
Description
1 Hood
2 Installation frame
No. in
fig. 9, page 7
Description
RMD10_INM_US.book Seite 20 Dienstag, 10. Dezember 2019 2:09 14
To Next Page
Loading...
