Using the refrigerator RMDX21, RMDX25
22
Inserting the shelf
➤ For fixed shelves only: Undo the locking pins with a screwdriver.
➤ Insert the shelf into the required position.
➤ Press the locks under the shelf outwards to secure the shelf.
➤ For fixed shelves only: Replace the locking pins again.
7.10 Defrosting the refrigerator
A
I
➤ Disconnect the voltage and gas supply.
➤ Empty the refrigerator.
➤ Put a cloth in the ice compartment and the refrigerator to absorb any excess
water.
➤ Leave the door open.
✓ The thawed water of the main refrigerator runs into a receptacle on the back of
the refrigerator where it evaporates.
➤ Wipe both compartments dry with a cloth.
NOTICE!
Never use mechanical tools to remove ice or to loosen objects stuck to
the device.
NOTE
Over time, frost builds up on the cooling fins inside the refrigerator. If this
layer of frost is about 3 mm thick, you should defrost the refrigerator.
2.
1.
3.
RMDX21-25--O-AU.book Seite 22 Freitag, 3. Februar 2017 5:10 17
To Next Page
Loading...
Need help?
General
