Dometic SeaWays - How to Engage and Disengage Seaways

3-3
EN
3.2.2 How to engage and disengage SeaWays
A single button press is all that’s required to engage SeaWays:
• From the run screen (shown below) you have the option of Heading,
Track, or Route.
• Route will only be available if a route has been setup and activated in the
chartplotter
• Press the desired autopilot mode.
Figure 3-4 shows a screen while pilot is engaged. SeaWays can be
disengaged by pressing the STBY button.
WARNING!
Engaging SeaWays causes the boat to steer without input from driver.
When using SeaWays all persons on the vessel should be secured.
The operator should never leave the helm station.
NOTE
SeaWays requires a GPS fix. In some conditions, this may require a few
minutes aer power on.
Figure 3-4.
Figure 3-5.
TrackHeading Route Menu