Dometic SeaWays - 2 Installation; Overview; Before You Begin

To Next Page

To Previous Page

2-1

2 Installation

SeaWays and SeaWays GO are integrated autopilot systems. SeaWays

builds off of an Optimus EPS or Optimus 360 system by adding a GPS and

heading sensor. The system uses position and heading data to steer the

vessel automatically.

The SeaWays GPS sensor allows Heading, Track, and Route modes

whereas the SeaWays GO compass allows Heading mode. For more

information on the three modes of operation, please refer to section 3.

Once your Optimus EPS or Optimus 360 system is installed, adding

SeaWays is simple:

1. Install the SeaWays or SeaWays GO sensor

2. Route network cable from sensor to Optimus network backbone

3. Apply Sensor license provided with kit (captured on back cover

of this booklet)

4. SeaWays commissioning

Before installing sensor:

1. Optimus EPS or Optimus 360 must be fully installed and commissioned

2. All software must be up to date – See book 65 for instructions on

updating software

2.1 Overview

2.2 Before you begin