Dometic SPX 1200-T - Remove Control PCB Holder; Disconnect Plugs and Cable Ties; Disconnect Connection Cable

4445104419 / 2024-04-23/ Page 3 of 4
FIGURE
6:
1. Carefully lift the black metal holder with the control PCB upwards out of the unit and
remove the marked plug from the control PCB.
CAUTION!
Some plugs have a locking device that must be pressed when removing the plug from
the control PCB.
FIGURE
7:
1. Cut the two cable ties and remove the marked plugs carefully from the control PCB.
CAUTION!
Some plugs have a locking device that must be pressed when removing the plug from
the control PCB.
FIGURE 8:
1. Release the 2 fastening screws of the connection cable.