Dometic TEC 29 - Switching the Generator to Standby or No Function; Switching the Remote Control On and Off; Starting the Generator; Stopping the Generator

EN
TEC29 EV Operating the generator
19
8.2 Switching the generator to standby or no function
The generator can be switched to standby or no function with the main switch
(fig. 3 1, page 4) in the control panel.
8.3 Switching the remote control on and off
This switch on the remote control (fig. 4 2, page 4) is for switching the remote
control on and off.
➤ Switch the remote control on with the on/off switch.
✔ The display shows:
GEN OFF.
The display switches off automatically after 5 minutes if the start button is not
touched within this time.
Press the start button to switch on the display again.
✔ The generator can now be started.
8.4 Starting the generator
The generator can only be started if it is in standby and the remote control is switched
on.
I
➤ Start up the generator with the start button (fig. 4 3, page 4).
8.5 Stopping the generator
➤ Stop the generator with the on/off switch (fig. 4 2, page 4).
If the generator does not stop: switch it off with the main switch (fig. 3 1,
page 4).
NOTE
If the generator is still warm, press the start button briefly to start it; press
longer for a cold generator.
DometicTEC29EV_OPM_4445103094_EMEA16_20xx-xx-xx.book Seite 19 Dienstag, 16. Februar 2021 3:20 15