Servicing the generator TEC30D EV
26
I
Check and change the fuel filter as follows (fig. 7, page 7):
➤ Remove the fixing cap (1) and the filter cover (2).
➤ Remove the knurled nut (3).
➤ Take out the air filter (4).
➤ Check the condition of the air filter (4) carefully:
Shine light into the air filter with a lamp and verify if the paper membrane is
damaged.
Replace the air filter:
–if damaged
– if soiled by humid or oily obstruction
➤ Clean the undamaged air filter of dry obstruction.
Clean the filter cartridge with dry compressed air (do not use jets of compressed
air with a pressure of more than 2 – 2.5 bar): Blow the air from the inside towards
the outside, until all the dust has been completely expelled.
➤ Clean the filter cover (2).
➤ Insert the air filter (4).
➤ Fasten the knurled nut (3).
➤ Mount the filter cover (2).
➤ Fasten the filter cover (2) with the fixing cap (1).
NOTE
If the air filter is dirty, the air flow to the motor is reduced. Check the
filter regularly so that the motor can function properly. Check this more
frequently if the generator is being used in particularly dusty
environments.
TEC30D-EV--O-16s.book Seite 26 Freitag, 10. März 2017 3:48 15
To Next Page
Loading...
Need help?
General
