Domo DO7295S - Frequently Asked Questions

33
DO7295S
www.domo-elektro.be
EN
MOTOR FILTER
The motor lter is located in front of the motor. Remove the dust reservoir. Take out
the lter. Clean it thoroughly. Allow it to air-dry properly. Replace it in the vacuum.
ATTENTION
· In a normal cleaning session, it is sucient to tap out the lters. It is
recommended that you thoroughly clean the lters under tepid running water 3 to 4 times per year.
Make sure that it is completely dry before putting it back in the appliance. You can also replace them if
necessary. Avoid direct sunlight or intense overheating. Never put the lters in the washing appliance
to prevent deformation. Do not use abrasive or cleaning products and wash from the bottom of the
lter.
· Make sure that all components are correctly assembled before using the vacuum cleaner again.
· Always use the vacuum cleaner with the lters intact. If you do not do this, you may lose suction force
or damage the motor.
· Unplug the plug before cleaning the lters.
· Do not use a hairdryer to dry the lters.
FREQUENTLY ASKED QUESTIONS
Problem Cause Solution
The appliance
does not start.
The appliance is not
plugged in.
Put the plug in the socket.
The appliance is not turned on. Press the on/o switch.
The appliance
stops working.
The appliance has overheated,
so the safety was tripped. This
can be caused by dirty lters or a
blockage.
Allow the appliance to cool completely. When the
appliance has cooled down, it will function again.
Clean the lters and check that the hose is not
clogged.
The suction is
too weak.
The appliance is not correctly
assembled, so the suction is
being lost.
Check that everything is assembled correctly.
Remove all of the accessories and then replace
them step by step in their place.
The dust reservoir is full. Empty the dust reservoir and make sure that it
does not exceed the maximum level.
The hose is clogged. Insert the hose in the reverse manner (with the
handle) in the suction opening of the appliance.
The clog will be suctioned to the other side,
which will free the hose.
The lters are dirty. Carefully clean the lters as described in this
manual. It is very important that you already
thoroughly clean the lters.
The valve on the handle of the
hose is open.
Close the valve.
The lters are congested. Over time, the pores in the lters will become
congested. Replace the lters.