26
DO8149
EN
4. Place the rear grill on the motor, making sure that the groove in the grill corresponds to the tongue
on the motor.
5. Tighten the grill with the large nut.
6. Place the fan blades on top of the unit so that the groove in the fan blades corresponds to the
tongue on the motor.
7. Tighten the fan blades with the nut.
8. Place the grill on the fan so that the grill clicks on the rear grill. Screw the unit into place using the
small screw at the bottom of the grill.
9. Place the aroma pad in the cover plate. Screw this plate into the middle of the grill in the provided
recess.
4
6
8
7
6
5
4
9
REMOTE CONTROL
You can also operate the device with the included remote control. Insert 2 AAA
batteries into the back of the remote control before use.
The remote control has a range of 5 metres.
USE
Plug the power cord into a socket. A beep indicates that the device is in standby mode. You can control the
fan from the control panel or with the remote control. Each time a button is pressed, the device emits an
audible signal and an indicator light lights up to indicate that the desired setting has been implemented. If
you do not implement a setting for one minute, the indicator lights will turn o automatically. The device
will continue to operate as usual.
CONTROL PANEL
Press this button to turn the device on or o. The fan starts working at the lowest speed or at the last set
speed. This can be seen from the indicator light that illuminates.
To Next Page
Loading...
Need help?
General
