To Next PageTo Next PageWhy is my Domus UDTT-2-25 Dryer not drying properly?
If your Domus Dryer isn't drying clothes adequately, try these steps: First, increase the cycle time. Then, ensure sufficient airflow by cleaning the fluff filter. Also, check that the output pipe is clean and unblocked, and clean the fan-extractor blades. Consider whether the outlet conduit is too long, and ensure the room has enough fresh air inlets.
What to do if my Domus UDTT-2-25 does not start?
If your Domus Dryer won't start, make sure the timer isn't set to 0 and select a correct time. Ensure the door and filter are fully closed. Verify that the dryer has a power supply by checking the condition of the fuses and that the mains voltage is correct.
How to fix a Domus UDTT-2-25 Dryer that is not heating?
If your Domus Dryer is not heating up, it might be in Cool-down mode; to return to heating, increase the time. Otherwise, check the thermostat and the control electronic plate. You may also need to check the safety thermostat and reset the GAS alarm, if applicable.
Rules for safe operation, including unattended use and user supervision.
Warnings against storing or using flammable substances near the dryer.
Guidelines for qualified installation, servicing, and electrical safety.
Provides a general overview of the dryer and detailed physical dimensions for various models.
Lists the necessary tools for installing the dryer.
Specifies the required space and positioning for correct operation and maintenance.
Details the requirements for the output pipe and exhaust system.
Outlines the procedure and requirements for connecting the dryer to the electrical supply.
Explains how to connect the gas supply and perform injector replacement for gas conversion.
Explains the electronic microprocessor control and user interface.
Details the meaning of indicator lights and programmed time displays.
Describes button functions in OPL and self-service modes, and self-service mode configuration.
Provides step-by-step instructions for starting and finishing a drying cycle in OPL/Self-service modes.
Describes the OFF, Main, and Run screens in OPL mode.
Details the sequence of screens for self-service operation (Selection 1, Payment, Run).
Explains how to manage and create drying cycles and programmable parameters.
Outlines various system settings like language, time, units, and access control.
Step-by-step guide to starting and operating drying cycles in OPL mode.
Instructions for starting and operating drying cycles via self-service payment.
Lists all alarm codes, their descriptions, and potential solutions for troubleshooting.
Instructions for cleaning the fluff filter, including frequency and safety precautions.
Guidance on cleaning the heating battery to ensure optimal performance and safety.
Details on cleaning fan blades, checking the extraction system, and non-return valves.
A table listing common dryer problems, their causes, and recommended solutions.
Information on the proper disposal of the machine according to European guidelines.
General
