8
EN
To reduce the risk of injury, user must read
instruction manual
WARNING
Always wear eye protection
Class II tool
Conformity of US
and CANADA
Technical data
DSA125/ASA125/KSA125 (The letter "SA" means Disk Sander)
Rated Power Input 3 A
Rated No-load Speed 4000-12000/min
Abrasive Disc Dia. 125 mm
Net Weight 1.4 kg
Intended Use
The machine is intended for dry sanding of
wood, plastic, ller and coated surfaces.
Instructions for Operation
● Switch Operation
Caution
：
Always be sure that the tool is switched
o and unplugged before installing or removing
the abrasive disc.
1
0
1
：
ON
0
：
OFF
1.Before plugging in the tool, always check to see that
the switch actuates properly and returns to the “OFF”
position.
2.Set the switch to the position of “1”for more
comfortable operation during operation. Always grip
the tools rmly.
3.Push the switch to the position of “1”, the tool will be
started. And push the switch to the position of “0” to
stop machine.
● Speed Control Dial
1
1.The rotation speed can be adjusted from 4000/
min to 12000/min by turning the speed control dial.
Higher speed is obtained when the dial is turned
in the direction of number 6. And lower speed is
obtained when it is turned in the direction of number
1.
● Installing or Removing the Abrasive Paper
1.To install the abrasive paper, rst remove all dirt or
To Next Page
Loading...
