dooch N747D - Page 38

38 BOOSTER PUMP SYSTEM
BOOSTER PUMP SYSTEM N747D
7. After changing to operation setup, make sure to press Key.
Set value is not changed until
input key is pressed.
The changeable items in user setting [3] are as below;
- RS485 : Select whether to use RS485communication or not.
Change of RS485 setting.
(Example: In case to change “No use” to “Use”.)
1. Using
Key, select .
2. Enter by using
Key.
: No use, : Use
4. After changing to required value, make sure to press
Key.
※ Set value is not changed until input key is pressed.
- Slave ID : Set Slave ID.
Range : 1 ~ 255
Change setting of Slave ID.
(Example: In case of to change 85 to 96)
1. Using
Key, select .
2. Initially the first ‘0’ of the ’085’ blinks.
3. Using
Key, enter by the order of 0, 9 and 6.
4. After changing to required value, make sure to press
Key.
※ Set value is not changed until input key is pressed.
- BAUD RATE : Select communication speed.
(0: 1200bps 1: 2400bps 2: 4800bps 3: 9600bps 4: 19200bps)