dooch Q-Drive NQ-0150-T - Page 10

[CONTENTS]
2 | DOOCHPUMP
[ Chapter 5. Operation ]
5.1 FND
5.1.1 Appearance and Description of FND
5.1.2 Functional Description of each Part
5.1.3 How to change Parameter Settings
5.2 Function Setup
5.2.1 Basic Function Setup
5.2.2 Expansion Function Setup
5.3 Basic Operation
5.3.1 Constant Pressure Control Mode
[ Chapter 6. Function Table & Description]
6.1 Display of present status
6.2 Pump Control Group
6.3 Drive Control Group
6.4 Description on Function of Parameter Settings
6.4.1 Pump Control Group
6.4.2 Drive Control Group
[ Chapter 7. Cause of Fault and Reaction ]
7.1 Fault History Table
7.2 Reset of fault and alarm
7.3 Cause of Fault and Reaction
[ Chapter 8. Appendix ]
8.1 RS-485
8.2 Peripherals
8.3 EMC filter