dooch Q-Drive NQ-0400-S - RS485 Communication ID, Speed, and Delay; CAN Communication Mode and ID Setup

[CHAPTER 6 FUNCTION TABLE & DESCRIPTION]
6-10 | DOOCHPUMP
Setup Data Functional Description
1~250(Factory Setting)
If the number of data request protocol is
different, data is not transmitted.
Pr-42 485 comm. speed
Pr-41 485 comm.
ㆍ 485 comm. speed set up
ㆍIt setsup 485 comm. ID set up
Setup Data Functional Description
1~9999(msec)
When receive data request protocol, data transmit
after set up delay time(Factory set up : 5[msec]
Pr-43 485 comm. delay time
ㆍ485 comm. delay time set up
Setup Data Functional Description
1200kbps1
2400kbps2
4800kbps3
9600kbps4(Factory Setting)
19200kbps5
Pr-50 CAN Communication Mode
ㆍ It set up for multi-drive control, when each drive has different version
* Available for version 1.3x. Please refer version check page
*
When set up for 0(NQ Ver 1.2x), the Pr-53 alteration automatically changed to 0(in order of ID)
Setup Data Functional Description
NQ Ver 1.2x0(Factory Setting)
NQ Ver 1.3x 1
Pr-51 Communication ID Setup
ㆍ It is CAN Communication ID on Multi-Drive control mode.
ㆍ Be sure to not duplicate ID for setup.