dooch Q-Drive NQ-0400-T - 2) Pump Control Function Setup

[CHAPTER 5 OPERATION]
5-5 |
DOOCHPUMP
2) Pump Control Function Setup
These parameters are to be set for the pump system when controlling pump using drive.
Setup Item
Parameter
Code
Description on Function
Pump Capacity Pr-01 To set up Pump Capacity
Pump Control Mode Pr-02 To set up Pump Control Mode
Sensor Capacity and
Correction
Pr-03~06
To set up capacity of pressure sensor and
correct variation between actual pressure
and pressure sensor
(On constant pressure control, Sensor2 is
not used.)
To Use Low Water
Level Sensor
Pr-76
To decide whether to use low water level
sensor
3) Drive Control Function upon External Command
These parameters are to be set basically when controlling the drive using external controller.
Setup Item
Parameter
Code
Description on Function
Frequency Setup upon
V1 Voltage
dr-60~63
To set up output frequency range against
voltage when controlling drive using V1
voltage
Frequency Setup upon
I1 Voltage
dr-64~67
To set up output frequency range against
current when controlling drive using I1
current
4) CAN Communication Function Setup
These parameters are to be set basically for CAN communication used on interoperation
or connecting FND/LCD Monitor.