Doogee S88 - Page 30

- Page 30 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
H.3.2.3 Monitoring voltage (V) ......................................... :

J INSULATED WINDING WIRES FOR USE WITHOUT INTERLEAVED INSULATION N/A
General requirements N/A
K SAFETY INTERLOCKS N/A
K.1 General requirements No safety interlocks inside the
EUT
N/A
K.2 Components of safety interlock safeguard
mechanism .........................................................
N/A
K.3 Inadvertent change of operating mode N/A
K.4 Interlock safeguard override N/A
K.5 Fail-safe N/A
Compliance ......................................................... : N/A
K.6 Mechanically operated safety interlocks N/A
K.6.1 Endurance requirement N/A
K.6.2 Compliance and Test method ............................. : N/A
K.7 Interlock circuit isolation N/A
K.7.1 Separation distance for contact gaps & interlock
circuit elements (type and circuit location) ......... :
N/A
K.7.2 Overload test, Current (A) ................................... : N/A
K.7.3 Endurance test N/A
K.7.4 Electric strength test ........................................... : N/A
L DISCONNECT DEVICES N/A
L.1 General requirements N/A
L.2 Permanently connected equipment N/A
L.3 Parts that remain energized N/A
L.4 Single phase equipment N/A
L.5 Three-phase equipment N/A
L.6 Switches as disconnect devices N/A
L.7 Plugs as disconnect devices N/A
L.8 Multiple power sources N/A
M EQUIPMENT CONTAINING BATTERIES AND THEIR PROTECTION CIRCUITS P
M.1 General requirements P