Doogee S88 - Page 29

- Page 29 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
G.15.2 Requirements N/A
G.15.3 Compliance and test methods N/A
G.15.3.1 Hydrostatic pressure test N/A
G.15.3.2 Creep resistance test N/A
G.15.3.3 Tubing and fittings compatibility test N/A
G.15.3.4 Vibration test N/A
G.15.3.5 Thermal cycling test N/A
G.15.3.6 Force test N/A
G.15.4 Compliance N/A
G.16 IC including capacitor discharge function (ICX)
N/A
a) Humidity treatment in accordance with sc5.4.8 –
120 hours
N/A
b) Impulse test using circuit 2 with Uc = to transient
voltage ................................................................ :
N/A
C1) Application of ac voltage at 110% of rated voltage
for 2.5 minutes
N/A
C2) Test voltage ........................................................ :

D1) 10,000 cycles on and off using capacitor with
smallest capacitance resistor with largest
resistance specified by manufacturer
N/A
D2) Capacitance ....................................................... :

D3) Resistance .......................................................... :

H CRITERIA FOR TELEPHONE RINGING SIGNALS N/A
H.1 General N/A
H.2 Method A N/A
H.3 Method B N/A
H.3.1 Ringing signal N/A
H.3.1.1 Frequency (Hz) ................................................... :

H.3.1.2 Voltage (V) ......................................................... :

H.3.1.3 Cadence; time (s) and voltage (V) ..................... :

H.3.1.4 Single fault current (mA):..................................... :

H.3.2 Tripping device and monitoring voltage .............. : N/A
H.3.2.1 Conditions for use of a tripping device or a
monitoring voltage complied with
N/A
H.3.2.2 Tripping device N/A