Doogee S88 - Page 33

- Page 33 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
Location and Dimensions (mm) ......................... :

P.2.3 Safeguard against the consequences of entry of
foreign object
N/A
P.2.3.1 Safeguards against the entry of a foreign object N/A
Openings in transportable equipment N/A
Transportable equipment with metalized plastic
parts .................................................................... :
N/A
P.2.3.2 Openings in transportable equipment in relation
to metallized parts of a barrier or enclosure
(identification of supplementary safeguard) ....... :
N/A
P.3 Safeguards against spillage of internal liquids N/A
P.3.1 General requirements N/A
P.3.2 Determination of spillage consequences N/A
P.3.3 Spillage safeguards N/A
P.3.4 Safeguards effectiveness N/A
P.4 Metallized coatings and adhesive securing parts N/A
P.4.2 a) Conditioning testing N/A
Tc (°C) ................................................................. :

Tr (°C) ................................................................. :

Ta (°C) ................................................................. :

P.4.2 b) Abrasion testing ................................................. : N/A
P.4.2 c) Mechanical strength testing ................................. : N/A
Q CIRCUITS INTENDED FOR INTERCONNECTION WITH BUILDING WIRING N/A
Q.1 Limited power sources N/A
Q.1.1 a) Inherently limited output N/A
Q.1.1 b) Impedance limited output N/A
- Regulating network limited output under normal
operating and simulated single fault condition
See appended table Annex Q.1 N/A
Q.1.1 c) Overcurrent protective device limited output N/A
Q.1.1 d) IC current limiter complying with G.9 N/A
Q.1.2 Compliance and test method N/A
Q.2 Test for external circuits – paired conductor cable N/A
Maximum output current (A) ............................... :

Current limiting method ........................................ :
