Doogee S88Pro - Mains Supply Cords and Varistors

- Page 26 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
G.5.4.1 General requirements P
Position ............................................................... :

G.5.4.2 Test conditions N/A
G.5.4.3 Running overload test N/A
G.5.4.4 Locked-rotor overload test N/A
Test duration (days) ........................................... :

G.5.4.5 Running overload test for d.c. motors in
secondary circuits
N/A
G.5.4.5.2 Tested in the unit N/A
Electric strength test (V) ...................................... :

G.5.4.5.3 Tested on the Bench - Alternative test method;
test time (h) ........................................................ :
N/A
Electric strength test (V) ...................................... :

G.5.4.6 Locked-rotor overload test for d.c. motors in
secondary circuits
P
G.5.4.6.2 Tested in the unit P
Maximum Temperature ...................................... : (See appended table B.4) N/A
Electric strength test (V) ..................................... : N/A
G.5.4.6.3 Tested on the bench - Alternative test method;
test time (h) ......................................................... :
N/A
Electric strength test (V) ...................................... : N/A
G.5.4.7 Motors with capacitors N/A
G.5.4.8 Three-phase motors N/A
G.5.4.9 Series motors N/A
Operating voltage ............................................... :

G.6 Wire Insulation
N/A
G.6.1 General N/A
G.6.2 Solvent-based enamel wiring insulation N/A
G.7 Mains supply cords
N/A
G.7.1 General requirements Not directly connected to mains N/A
Type..................................................................... :

Rated current (A) ................................................. :

Cross-sectional area (mm
2
), (AWG) .................. :

G.7.2 Compliance and test method N/A
G.7.3 Cord anchorages and strain relief for non-
detachable power supply cords
N/A