Doogee S88Pro - Page 27

- Page 27 of 60 -
Report No. STS200421001001E
IEC/EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
G.7.3.2 Cord strain relief N/A
G.7.3.2.1 Requirements N/A
Strain relief test force (N) .................................... :

G.7.3.2.2 Strain relief mechanism failure N/A
G.7.3.2.3 Cord sheath or jacket position, distance (mm) .... :

G.7.3.2.4 Strain relief comprised of polymeric material N/A
G.7.4 Cord Entry .......................................................... : N/A
G.7.5 Non-detachable cord bend protection N/A
G.7.5.1 Requirements N/A
G.7.5.2 Mass (g) ............................................................. :

Diameter (m) ....................................................... :

Temperature (C) ................................................ :

G.7.6 Supply wiring space N/A
G.7.6.2 Stranded wire N/A
G.7.6.2.1 Test with 8 mm strand N/A
G.8 Varistors
N/A
G.8.1 General requirements No varistors used. N/A
G.8.2 Safeguard against shock N/A
G.8.3 Safeguard against fire N/A
G.8.3.2 Varistor overload test .......................................... : N/A
G.8.3.3 Temporary overvoltage ....................................... : N/A
G.9 Integrated Circuit (IC) Current Limiters
N/A
G.9.1 a) Manufacturer defines limit at max. 5A. No such IC used. N/A
G.9.1 b) Limiters do not have manual operator or reset N/A
G.9.1 c) Supply source does not exceed 250 VA ............ :

G.9.1 d) IC limiter output current (max. 5A) ...................... :

G.9.1 e) Manufacturers’ defined drift ................................ :

G.9.2 Test Program 1 N/A
G.9.3 Test Program 2 N/A
G.9.4 Test Program 3 N/A
G.10 Resistors
N/A
G.10.1 General requirements N/A
G.10.2 Resistor test N/A