- Page 46 of 60 -
Report No. STS200421001001E
EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
5.2.2.5 - Repetitive Pulses
No.
Supply
Voltage
Location (e.g.
circuit
designation)
Test conditions
Parameters
ES Class
Off time (ms) Upk (V) Ipk (mA)
-- -- -- Normal -- -- --
--
Abnormal -- -- --
Single fault –
SC/OC
-- -- --
Test Conditions:
Normal –
Abnormal -
Supplementary information: SC=Short Circuit, OC=Open Circuit
The prospective touch voltage was measured when the flash device was ignited.
5.4.1.4,
6.3.2, 9.0,
B.2.6
TABLE: Thermal requirements P
Supply voltage (V) .......................... : Condition 1 Condition 2 -- --
Ambient T
min
(C) ............................ :
See below See below
--
--
Ambient T
max
(C) ............................ :
See below See below
--
--
Tma (C) ………………………..……:
See below See below -- --
Maximum measured temperature T of
part/at......:
T (C)
Allowed
T
max
(C)
Battery body 52.3 51.3
-- --
Ref.
PCB near IC3 63.7 56.0
-- --
130
PCB near IC1&IC2 72.0 64.0
-- --
130
Shielding case 61.3 59.0 -- --
Ref.
Enclosure inside near Battery 50.6 49.9
-- --
Ref
Ambient 35.0 35.0
-- -- --
Touch temperature clause 9.0
DC inlet 37.3 34.5
-- --
77
Enclosure outside near Battery 39.7 38.8
-- --
48
Screen 38.6 37.9
-- --
48
Adapter surface 42.4 --
-- --
77
To Next Page
Loading...
