Doogee S88Pro - Page 47

- Page 47 of 60 -
Report No. STS200421001001E
EN 62368-1
Clause Requirement + Test Result - Remark Verdict
Shenzhen NTEK Testing Technology Co., Ltd
Ambient
25.0 25.0
-- --
--
Supplementary information:
Condition 1: the most unfavorable 12V charging condition.
Condition 2: discharging full battery, normal operation.
Temperature T of winding: t
1
(°C)
R
1
()
t
2
(°C)
R
2
() T (C)
Allowed
T
max
(C)
Insulati
on
class
-- -- -- -- -- -- -- --
Supplementary information:
5.4.1.10.2 TABLE: Vicat softening temperature of thermoplastics N/A
Penetration (mm) ......................................................... :

Object/ Part No./Material Manufacturer/t
rademark
T softening (°C)
-- -- --
Supplementary information:
5.4.1.10.3 TABLE: Ball pressure test of thermoplastics N/A
Allowed impression diameter (mm) .................................. :
 2 mm

Object/Part No./Material Manufacturer/trademark
Test temperature (C)
Impression diameter (mm)
-- -- --
--
Supplementary information:
5.4.2.2,
5.4.2.4 and
5.4.3
TABLE: Minimum Clearances/Creepage distance N/A
Clearance (cl) and creepage
distance (cr) at/of/between:
Up
(V)
U r.m.s.
(V)
Frequency
(kHz)#
Required
cl (mm)
cl
(mm)
Required
cr (mm)
cr
(mm)
Basic/supplementary insulation
-- -- --
--
-- -- -- --
Reinforced insulation
-- -- --
--
-- -- -- --