MAINTENANCE Operating & Maintenance Manual
45
8. Apply 2 medium - wet coats of Duponts
222S Adhesion Promoter over the entire
area to be painted, with a 5 minute flash
in between coats.
9. To apply the texture coat, use Duponts
1854S Tuffcoat Primer. The proper
technique to do this is to spray the
Tuffcoat Primer using a pressure pot and
use about 2-5 pounds of air pressure.
This will allow the primer to splatter
causing the textured look.
NOTE: You must be careful not to put too
much primer on at one time, this will effect
the amount of texture that you are trying to
achieve. Allow the texture coat to flash for 20
minutes or until dry to touch.
10. Apply any of Duponts Topcoat Finishes
such as Imron™ or Centari™ according
to the label instructions.
NOTE: To re-topcoat the textured surfaces
when sheet metal repairs are not necessary,
follow steps 1, 2, 4, 5, 6, 8 and 10.
To Next Page