Dorel DA6580 - Slats and Ladder Assembly

NOTE: If you notice that any of the slats (L) are not perfectly flat, be sure to attach them so that
the slats (L) curves up in the middle and down on the ends.
LOFT BED WITH DESK
DA6580
STEP 9
Attach a slat (L) onto top side rails (I & J) of the top bunk with flat head screws (4). Make sure the
slat touches the corner posts (as close to the headboard as possible). Attach the other slats (L)
onto the top side rails (I & J) with flat head screws (4). Use space block (Y) to space them out
evenly as shown. Use Phillips screwdriver (not included) to tighten flat head screws (4).
L
I
J