STEP 4
Attach a bottom slat (X) to bottom side rails (J) with flat head wood screws (4). Make sure the slat
touches the corner posts (as close to the headboard as possible).
Attach the other slats (X & Y) to the bottom side rails (J) with flat head wood screws (4) using a
Phillips head screw driver (not included). Use space block (A1) to space them out evenly as shown.
NOTE: If you notice that any of the slats (X & Y) are not perfectly flat, be sure to assemble them so
that the slats (X & Y) curves up in the middle and down on the ends.
Attach the support posts (W) to bottom slats (Y) of the bottom bunk with hex socket head bolts (8) as
shown.
TWIN/FULL BUNK BED
14 PCS
4
8
3 PCS
DA6940E (ESPRESSO) / DA6940W (WHITE)/ DA6940BL(BLUE)
To Next Page
Loading...
