27
6 Installation
In order to install the pushbutton, the rocker buttons
must be removed first. Lay the electronics unit with the
attached rockers in front of you on the table. Use a small
flat screwdriver to slip into the gaps in the side of the
No return springs are attached to pins on the back of
the rocker buttons. Make sure that these springs are
not lost. Ensure that these springs are installed properly
again before mounting the unit again.
adhesive plates. When fastening with screws, align the
fastening holes are made as oblong holes so that any
subsequently required slight adjustments can be made.
To Next Page
Loading...