36
BRC-WDORMA
9 Resetting to original settings
Hold the teach button down for at least 5 seconds. The
abort the reset procedure at this time, you can press the
teach button briefly again or wait 15 seconds. In either
To reset the device, press the teach button again for at
least 5 seconds. The LED starts to flash in red faster while
the button is held down. Releasing the button completes
the reset procedure and the LED is illuminated for approx.
3 seconds to confirm the reset operation.
Possible error messages:
If the LED does not start flashing after holding the button
down for 5 seconds but is illuminated continuously, the
device cannot be reset! In this case, the encoding is
active using a system security key that differs from the key
delivered with the system.
To Next Page
Loading...