Dormakaba EPS DCW Series User Manual

WN 056751 45532/15299
2023-03
DE | EN
EPS-DCW
Betriebsanleitung
Operating instructions
Elektronischer Programmschalter DCW
Electronic program switch DCW
2014/30/EU
EMC Directive
Technische Daten
Versorgungsspannung: 24 VDC typ.
8 V DC min.
35 V DC max.
Stromaufnahme:
EPS-D DCW
EPS-S DCW
EPS-FST DCW
30 mA typ. / 50 mA max.
30 mA typ. / 45 mA max.
40 mA typ. / 65 mA max.
Eingang: 24 V, low active
Schutzart: IP 40
Schnittstelle: DCW
Länge der
Anschlussleitung:
30 m max.
Technical Data
Supply voltage: 24 V DC typ.
8 V DC min.
35 V DC max.
Current consumption:
EPS-D DCW
EPS-S DCW
EPS-FST DCW
30 mA typ. / 50 mA max.
30 mA typ. / 45 mA max.
40 mA typ. / 65 mA max.
Input: 24 V, low active
Protection class: IP 40
Inteface: DCW
Length of connector
cable:
30 m max.
EPS-S DCW
für Schiebetüren
for sliding doors
EPS-FST DCW
für Fluchtwegschiebetüren
for escape route sliding doors
EPS-D DCW
für Drehtüren
for swing doors
1
2
3
4
5
GND
DCW
DCW
+24 V
Option Schlüsselschalter/-taster
Option Key Switch/
-operated push button
6 polige Klemmleiste (steckbar)
6-pin terminal strip (pluggable)
3
B
A
1
DCW Adresse (Brücke)
DCW address (Jumper)
HL
ACHTUNG
Es ist unbedingt auf die richtige Polarität
beim Anschluss des Programmschalters an
die Steuerung zu achten! Andernfalls können
Steuerung und Programmschalter zerstört
werden.
ATTENTION
Pay attention to the correct polarity when
connecting the program switch to the
control unit! Otherwise, the control unit and
program switch may be destroyed.
HL

Dormakaba EPS DCW Series Specifications

General

Brand	Dormakaba
Model	EPS DCW Series
Category	Switch
Language	English

Summary

Introduction and Technical Data

DCW Addressing

Configuration of the DCW address using a jumper on the device.

Safety Warnings

Crucial polarity warning for connecting the program switch to prevent damage.

Technical Data

Specifications including supply voltage, current consumption, input, protection class, and cable length.

Commissioning

Connecting the Device

Instructions for making connections and supplying 24 VDC power.

Code Change

Procedure to change the device's access code, including factory reset.

Unlocking via Key Switch or Pushbutton

Setting up exclusive unlocking via external key switch or pushbutton.

Forgotten Code Procedure

Steps to reset the program switch code to default if forgotten.

Operation Manual

Changing Operating Mode

How to unlock the switch and select different operating modes.

Power Failure Behavior

How the program switch behaves after a power interruption.

Malfunction Indicator

How to interpret the red LED for fault indication on escape route doors.

Special Functions

Reset Function

Initiating a control unit restart using specific key presses.

Service LED

Indication of service requirements based on drive cycles or time intervals.

Locked LED

Indicator showing when the door is locked in the closed position.