20195 South Diamond Lake Road, Suite 100 • Rogers, MN 55374 / Toll-Free: 800-822-0295 / Fax: 763-428-4821 / www.dosko.com
Model 200-6H
Know Your Dosko:
Please reorder as needed.
These safety sheets are free of charge. Additional safety sheets are available online for your convenience at
www.dosko.com. They are also available by contacting Great Northern Equipment Distributing, Inc. at
800-822-0295 and requesting Item # E786116.
NOTE:
Please make sure that your customers sign the back of this safety sheet indicating they have read and
understand the operating and safety instructions.
BEFORE GRINDING STUMPS
• Be aware of all underground utilities before grinding stump.
STARTING GRINDER
• Lock handle in the upright, operating position.
• Pull out on-off switch (located on control panel).
• Turn switch to “On” position (located on engine).
• Pull choke if engine is cold (located on engine).
• Engage operator presence handle located on left side of
operating station by pushing handle (small diameter bar)
towards “Handle Bar Bow.”
• Pull recoil rope to start engine (located on engine).
• When engine starts — close choke.
• Press down on handle bar so that cutter wheel is off the
ground.
• Press throttle lever/bail (located on right side) towards
“Handle Bar Bow.” Engine will increase and centrifugal clutch
will engage and begin rotating cutter wheel automatically.
GRINDING STUMP
• Push grinder to stump so that the stump is located just in
front of the cutter wheel.
• Using the brake lever — lock the one wheel.
• Pull throttle to full open (located on engine).
• Lower the cutter wheel slowly using a left-to-right motion to
grind the stump.
• Grind stump to desired depth.
• Reposition grinder further on stump and begin this process
again.
• Release handle to disengage.
• Allow cutter wheel to stop before resting it on ground.
: CUTTING WHEEL WILL CONTINUE TO
TURN FOR A SHORT PERIOD AFTER ENGINE IS SHUT OFF.
Item # E786116
Operating instructiOns
Before Starting or uSing thiS machine, read and review thiS Safety Sheet! Be aware of all pOtential dangers,
protect windowS and vehicleS from poSSiBle flying deBriS and Be aware of all necessary safety precautiOns!
Cutting Tooth
Cutter Wheel Disc
Discharge Flap
Belt Guard
Folding Handle Lock
Adjustable Brake Lever
Handle Bar
Gas Tank
Engine Throttle & Choke
Operator
Presence Handle
Operating Station
Throttle Lever/Bail
Handle Bar Bow
On-Off Switch
Side Discharge Frame
Air Filter
Recoil Rope
Folded Down Position
To Next Page
Need help?
General
