Need help?Do you have a question about the Doughboy AquaView 0-1709-014 and is the answer not in the manual?
Requirements for permits and local regulations for filter installation.
Recommendation for qualified electrician for electrical power supply installation.
Filter placement for safety, minimum distance from pool to prevent climbing.
Importance of proper support to prevent damage from vibration or settlement.
Ensuring access for inspection, repair, or replacement of components.
Use of GFCI protected receptacles to prevent risk of electrical shock.
Warning against burying cords to prevent accidental damage from equipment.
Danger of electrical equipment with wet feet or on wet ground.
Always unplug pump from receptacle before servicing, adjusting, or repairing.
Proper placement of filter and pump at least 6 feet from pool for safety.
Correct placement of filter and pump as shown in diagram for sand installation.
Instructions for pouring the correct #20 grade filter sand into the tank.
Step to remove the multi-position valve from the filter tank.
Instructions to slip a plastic bag over the riser tube before adding sand.
Gently pour filter sand into tank and level the surface with palm.
Process for reinstalling the valve with o-rings and securing the tank clamp.
Connecting suction and return lines to the filter and pump correctly.
Refer to pump guide for details on safe electrical installation.
Completing pool filling to the correct water level per skimmer instructions.
Normal pool filtering position, also usable for vacuuming.
Reverses water flow to flush out dirt and debris to waste.
Position used after backwashing for flushing, normally for 10 seconds.
Allows vacuuming heavy debris or settled contaminants directly to waste.
Circulates water rapidly, bypassing internal filter components.
Allows draining of trapped water from the filter valve for storage.
Stops water backflow when servicing the filter or pump.
Loosening the strainer pot lid to allow air to escape.
Plugging the pump into a GFCI protected receptacle.
Pushing down valve handle and rotating to BACKWASH position.
Allowing 4-5 minutes for flushing fine sand grains to prevent clogging.
Rotating valve to FILTER position and noting pressure gauge reading.
Checking all fittings and hoses for leaks and correcting if necessary.
Continuous filtering for 24-48 hours for newly filled pools.
Generally 6-8 hours of filtering daily is sufficient for pool clarity.
Avoid operating filter during peak electricity demand times.
Backwash when pressure gauge increases 5-7 pounds above clean filter pressure.
Normal backwash duration is 1.5-2 minutes or until water runs clear.
Filter works harder during vacuuming, causing rapid pressure increase.
Frequent backwashing may be necessary due to vacuuming debris.
Use silicone lubricants only; avoid petroleum-based products on plastic parts.
Applying silicone lubricant on the valve shaft o-ring.
Servicing should be performed by a qualified dealer; mark parts for reassembly.
Procedure to drain the filter tank, including removing the drain cap.
Instructions for removing and storing components indoors in freezing areas.
Causes and remedies for high pressure and low return flow.
Causes and remedies for low flow, pump sucking air, or rattling sounds.
Causes and remedies for high/low pressure when pool water remains cloudy.
Causes and remedies for filters requiring frequent backwashing.
Causes and remedies for sand particles found in the pool water.
Causes and remedies for water leaking from the waste line.
General| Brand | Doughboy |
|---|---|
| Model | AquaView 0-1709-014 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
