Need help?Do you have a question about the Doughboy Media Master 1600 and is the answer not in the manual?
Local building codes may require permits and regulations for electrical installations and setbacks.
Recommends a qualified electrician for safe electrical power supply installation as specified.
Position filter and pump at least 4 feet from the pool to prevent child access.
Components should be properly supported to prevent damage from misalignment or vibration.
Install circulation system components for easy accessibility for inspection, repair, or replacement.
Plug pump into a GFCI protected receptacle and ensure adult supervision for children.
Position cords to prevent accidental damage from lawn equipment, reducing severe shock risk.
Avoid touching electrical equipment with bare feet on wet ground to prevent severe shock.
Always unplug the pump from the receptacle before servicing, adjusting, or repairing it.
Place components 4ft from pool, using patio blocks for firm support and to keep areas dry.
Position filter and pump on a prepared pad as illustrated in the diagram.
Use #20 grade filter sand with sharp edges for peak performance; avoid rounded sand.
Loosen tank clamp screws counter-clockwise to remove the cover.
Lift the cover off the tank and remove the large O-ring.
Slip a plastic bag over the riser tube and secure it with a rubber band.
Gently pour 150 lbs of #20 filter sand into the tank and level the surface.
Position O-ring, place cover, align, and tighten tank clamp screws securely.
Connect hoses for suction, return, and pump discharge, ensuring no restrictions.
Normal pool filtering position, also usable for vacuuming the pool.
Reverses water flow to flush filter; waste water discharged to waste port. Duration 1-2 min.
Position used after backwashing to discharge filtered water to waste for about 10 seconds.
Allows vacuuming heavy debris or settled contaminants directly to waste.
Increases water flow rate to circulate chemicals quickly throughout the pool.
Drains trapped water from the valve to relieve gasket compression during storage.
Backwash when pressure gauge increases 5-7 lbs above clean filter pressure.
Frequent backwashing may be needed due to rapid debris capture during vacuuming.
Use silicone lubricants for moving parts; avoid petroleum-based lubricants that degrade plastic.
Lubricate O-ring on valve shaft by depressing handle and applying lubricant.
Remove clamp, cover, O-ring, drain cap, and scoop out sand for servicing.
Backwash filter, lower pool water, remove components, drain tank, and store indoors.
General| Brand | Doughboy |
|---|---|
| Model | Media Master 1600 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page
