l Radar LR120: For Siemens Radar transmitter LR120 (see Appendix in this manual for
the setup).
g. Density: Select Densimeter if a density measurement float is installed on the probe
(applicable to DMP probes only).
NOTE: For DMP 1-wire probes (LX Plus models only):
For console software versions earlier than 4.17.9 in combination with DMP
probes with firmware version older than v08, the probe needs to be configured
firstly via RS485 (with the dedicated DMP Probe Config Manager) in order to
use the densimeter.
For console software version 4.17.9 and later in combination with DMP
firmware version v08 and later, there is no need for the above requirement
and the console can push the configuration to the probe.
NOTE: For DMP RS485 probes: The density configuration for DMP 485
probes can be pushed to the probe by the console.
h. Select the Water detection type from the drop-down:
l Not installed: Water float is not installed on the probe
l Water float: Water float is installed on the probe
l AEF: Aqueous Ethanol Float installed in the place of the standard water float.
i. Select the status of Water detection from the drop-down:
l Enabled: The water float is present and measurements will be available and taken into
processes (this setting will send the “two floats” information to DMP Probe)
l Ignored: The water float is installed but no measurementsare processed,, Water
values are shown as “0”.
l Ignored during delivery: The water float is present and measurements will be
available and taken into processes. However, when the delivery is detected, the last
measurements will be locked and shown to not cause false alarms during delivery.
Once the delivery has completed, the water measurements will be unlocked.
j. Offset product: This value is used to calibrate the position of the product float. Possible
value range: ±5000 mm (197 in).
k. Offset water: This value is used to calibrate the water float Possible value range: ±5000
mm (197 in).
l. Water Min Float Level: This is the threshold to set the water volume at zero and show the
water level.
M2051_r4 MagLink LX 4 and LX Plus Configuration Manual | Dover Fueling Solutions 35
To Next Page
Loading...