Dover TWG TULSA WINCH 1200W User Manual

http://www.tulsawinch.com
SEL-0061-001
REV 0 July 2020
TABLE OF CONTENTS
SAFETY NOTES .......................................................................................................................... 2
INTRODUCTION AND THEORY OF OPERATION ........................................................................ 3
HYDRAULIC SCHEMATIC........................................................................................................... 4
MAINTENANCE AND SERVICE ................................................................................................... 5
WIRE ROPE ............................................................................................................................... 7
DISASSEMBLY ........................................................................................................................... 8
ASSEMBLY ................................................................................................................................. 9
SERVICING THE MOTOR ......................................................................................................... 10
SERVICING THE BRAKE........................................................................................................... 11
SERVICING THE PLANETARY SETS ......................................................................................... 13
TROUBLESHOOTING ............................................................................................................... 14
TORQUE SPECIFICATIONS CHART.......................................................................................... 15
BILL OF MATERIAL.................................................................................................................. 16
EXPLODED ISOMETRIC ASSEMBLY DRAWING ....................................................................... 19

Dover TWG TULSA WINCH 1200W Specifications

General

Brand	Dover
Model	TWG TULSA WINCH 1200W
Category	Winches
Language	English

Summary

Introduction and Theory of Operation

Hydraulic Schematic

Maintenance and Service

Maintenance Scheduling

Outlines inspection intervals based on usage categories, following industry standards.

Oil Level Maintenance

Recommends checking and adjusting oil levels in gearbox and brake housing during pre-use inspections.

Oil Change Interval

Specifies changing gearbox and brake oil every 1000 hours or 6 months of usage.

Recommended Oil

Oil Capacity

Lists the specific oil quantities required for the gearbox and brake sections.

Oil Change Procedure

Disassembly Instructions

Assembly Procedure

Servicing the Motor

Servicing Gear Motors

Provides specific servicing instructions for gear-type hydraulic motors.

Servicing Geroler Motors

Provides specific servicing instructions for geroler-type hydraulic motors.

Servicing the Brake

Servicing Planetary Sets

Troubleshooting Guide

Torque Specifications Chart

Bill of Material

Exploded Isometric Assembly Drawing