Down East 2002 model year - Spa Modes and Error Indicators; LCD Error Indicator and Troubleshooting

____________________________________________________________________________________________
__________________________________________________________________________________________
14
MODE
MODEMODE
MODE
Mode is changed by pressing the “Temp” button, then pressing the “Light “button.
Standards Mode is programmed to maintain the desired temperature. Note that the last
measured spa temperature displayed is current only when the pump has been running for
at least 2 minutes. “St” will be displayed momentarily when you switch into Standard
Mode.
Economy Mode heats the spa to the set temperature only during filter cycles. “Ec” will
display solid when temperature is not current, and will alternate with temperature when
temperature is current.
Sleep Mode heats the spa to within 20° F of the set temperature only during filter cycles.
“SL” will display solid when temperature is not current, and will alternate with
temperature when temperature is current.
LCD
LCDLCD
LCD ERROR
ERRORERROR
ERROR INDICATOR
INDICATORINDICATOR
INDICATOR
Your LCD will readout the following if any problems are detected:
MESSAGE MEANING ACTION REQUIRED
No message on display. The control panel will be disabled until
Power has been cut off to power returns. Spa settings will be
the spa preserved for 30 days with a battery
back-up.
- - Temperature unknown. After the pump has been running for 2
minutes, the temperature will be displayed.
HH “Overheat” – The Spa has DO NOT ENTER THE WATER.
shut down. One of the Remove the spa cover and allow water to
sensors has detected 118°F cool. Once the heater has cooled, reset by
at the heater. Pushing any button. If spa does not reset,
shut off the power to the spa and call your
dealer or service organization.
OH “Overheat” – The Spa has DO NOT ENTER THE WATER.
shut down. One of the Remove the spa cover and allow water to
sensors has detected 110°F. cool. At 107°F, the spa should
automatically reset. If spa does not reset,
shut off the power to the spa and call your
dealer or service organization.