Storage and Maintenance
The PRIME FIT TM TREADMILL can be moved and stored quite easily. Simply keep it in a .cle.an,dry, and convenient place, if
FREADMILL iSto be stored for more _an 30 days, it iSI_est to remove BATTERiES (Not Inczu_ed) from MONITOR(No. 2). The
:_ EADMILL should require little actual maintenance other _an perk_dtcallyspr.aymga silicon|ut_flcantunder TREADBELT (No.
):8), Keep TREADMILL clean to avoid deterioration of TREADBELT and ftnisn,
t'he TREADBELT (No. 128) has been factory pre-adjusted. However, if it shifts to one side or the other, follow these stepsto
readiustit.
1, If TREADBELT has moved to dght, tlghten doht ADJUSTMENT BOLT (No, 133) 1i2 turn while TREADMILL is running and
no one ts on it. The TREADBELT should move towards left.
2. Let TREADMILL run several turns of TREADBELT and note any sideways movement.
3, If only a small amount of ¢ttange occurred, loosen I_ft ADJUSTMENT BOLT (No. 133) 1/2 turn.
4. Repe=tt step 2.
Repeat steps i _mugh 4 untilTREADaELT iscentered and remalns there dudng use, If TREADEELT has moved to LEFT, fop
low steps 1-4 but start wtttl LEFT side. -
_: if TREADaELT is slipping it will be necessary to ttg_en both ADJUSTMENT BOLTS until slipping has stopped, it may
then be necessary to repeat steps 1 tl_mugt_4 for alignment.
CAUTION: DO NOT OVERTIGHTEN TREADBELT. Otertlgh'tenin_ Is denoted by Curlingof the edges of the TREADBELT.
IF NO SPEED OR DISTANCE is displayed on MONITOR (No. 2) check the following:
i, The wine of REED SWITCH (No. 136) ftorn CONSOLE (No, i02) isplugged into the MONITOR (No. 2).
2. The BATTERIES are not weak or dead,
3. The REED SWITCH (No. 136) and MAGNET on the FRONT ROLLER (No. 126] =ireIn the correct position, it may be neces-
sary to te=llgn the REED SWITCH with the MAGNET, Followthese steps to realign it:
a, _.._: Unplug the TREADMILL. MAGNET i/8"
b, Remove MOTOR COVER (No. 123) - see Rgure 5,
c. Check spacing and allcjnrnent between MAGNET on left sideof FRONT ROLLER
(,NO,t28) and REED _WlTCH (NO. 136) on the TREAOMILLFRAME (No. 110)-
see FIGURE 3. The,spacing must be 1/8" and the edge of the REED SWITCH
| be aligned w_h the center of the MAGNET. Move REED SWITCH on
TREAOMILL_FRAME,
_: 1/8" is equal to the thickness of two pennies.
d, Reattach MOTOR COVER (No. 123).
l=
BATTERIES: Use four "AA" batteries to power MONITOR (No. 2). It is recommended
that alkal{_e batteries be used for longer battery life. Rechargeable batteries ate not recom-
mended. TO extend battery life, turn MONITOR off after use.
SWITCH .................
' 136
FOR ANSWERS TO ANY OTHER MAINTENENCE QUESTIONS CONTACT OUR CUSTOMER SERVICE DEPARTMENT
FOR SERVICING RECOMMENDATIONS. SEE PHONE NUM8ERS ON FRONT PAGE.
FIGURE 3....
To Next Page
Loading...