MACH 130F/130 Ceiling, Wall, Stand model
Dr. Mach
Lamps and Engineering
1. Safety instructions
Please pay attention to the directions for use when handling the lamp.
Attention:
This device is not suitable for use in hazardous locations. The lamp is classified
as a Group 1 device according to the Regulations for EEMP.
Repairs to the lamp and special installation work on the reflector or plug-in socket should
only be carried out by ourselves or a company expressly authorised by ourselves.
The manufacturer is only responsible for the safety of the lamp if repairs and alterations
have been carried out by themselves or a company who can guarantee that the safety
regulations have been observed.
The manufacturer is not liable for personal or material damages if the lamp is misappro-
priately or incorrectly operated or misused.
Make sure that the lamp is in perfect working order before every use.
The lamps Mach 130F/130F 22,8V UL and Uniflex R96 120V UL may not be used
without the dielectric filter disk.
The dielectric filter disk between reflector and protective disk prevents a damaging heating
of the illuminated area.
The lamps Mach 130 may not be used without the conversion filter.
The lamp body may only be dismantled from swivel arm the (in reverse order to its assem-
bly) after the arm has been secured since the arm is under spring tension.
Installation of Mach 130/130F with electronic transformer 230V
Installing the lamp connect the phase to the ON/OFF switch. The voltage of the neutral line
has to be less than low voltage.
59100001 Edition 12 07.02.2005 / Bak Page 3/28
To Next Page
Loading...
