8. The use of the non-motion mode.
In fact, the sensitivity in the non-motion mode is high, search metals
directly using non-motion mode is also a choice. In some regions, the
ground is too narrow to sweep search coil, you could choose the
PINPOINT mode. In the severe mineralization or saline region, and in
the places where there is too much interference, you could try to
sweep using PINPOINT directly.
CAUTION
1) In areas with heavy traffic, please not wear earphone, in case an
accident occurs.
2) Always obtain permission before searching any site.
3) Keep away from the region where may bury the electrical line, cable
line or pipeline, in particular, the pipes that are full of flammable gases
and liquids.
4) Do not detect in the military area where may bury bombs or gas
explosives.
5) When excavating the target, use the reasonable method, not destroy
the vegetation. Leave the land and vegetation as it was, fill in the holes
after the excavation.
To Next Page
Loading...
