CONTACT US AT w w w .DRpow er.com 27
Dumping
1. Shut down the Mower and Vacuum Engines and set the Mower Parking
Brake when you are at the Dump area.
2. Separate the left and right side Doors by disconnecting the three Buckles
(Figure 69).
3. Attach the top Buckles of the side Doors to the Buckles at both sides of the
Enclosure (Figure 70).
4. Separate the top and bottom Doors by disconnecting the three Buckles
(Figure 71).
5. Pull the Dump Lever to tip the Collector back (Figure 72). Push against the
Top Tube Frame to start the tipping (Figure 73). Help slide the Enclosure
Sleeve off the Outlet Chute if necessary.
6. Drive the Mower forward with the Collector fully open to move the Leaf
System away from the pile of debris and allow all debris to slide from the
Bed.
7. Shake the Collector if necessary to loosen any debris that remains in the
bottom.
8. Pull down at the front of the Collector until the Latch is secured by the Dump
Lever (Figure 72).
9. Close the Top and Bottom Doors and secure the three Buckles.
10. Undo the Buckles at the sides, close the Left and Right Doors and secure
with the three Buckles.
Enclosure
Sleeve
Figure 73
Outlet
Chute
Top Tube
Frame
Dump
Leve
Figure 72
Unlock
Collector
Lock Collector
Latch
Side Buckle
Figure 70
Side Door
Flap
Buckles
Figure 69
Left
Side
Right
Side
Always shut off the tractor engine and the vacuum engine and use caution
when dumping the collector load.
Never back up with the Collector in the dump position.
Never drive in reverse with the Collector in the dump position.
Buckle
Figure 71
Top
Bottom