CONTACT US AT w w w .DRpow er.com 29
Converting to Flatbed Trailer Mode
Tools Needed:
Flat Head Screwdriver or 9/32" Wrench
Two 3/4" Wrenches
1. Remove the Rubber Bungee from the Hose Support (Figure 75).
2. Remove the Hose Support from the Bracket.
3. Disconnect the Hose from the Impeller Housing using a Flat Head
Screwdriver or 9/32" Wrench (Figure 76).
4. Turn the Thumb Screw Clamp to disconnect the Hose from the Deck
Adapter (Figure 77).
5. Pull the Enclosure Sleeve from the Outlet Chute (Figure 78).
6. Remove the six Knob Bolts from under the Collector Base corners (Figure
79).
7. Loosen the Knobs at the top corners (you do not need to remove them).
8. With help from another person, lift the Enclosure from the Flatbed and set it
aside.
Remove six
Bottom Knobs
Figure 79
Loosen four
Top Knobs
Enclosure Sleeve
Figure 78
Outlet
Chute
Hose
Figure 75
Rubber Strap
Hose Support
Hose Clamp
Figure 76
Impeller Housing
Hose Adapter
Inlet Hose
Figure 77
Deck
dapte
Thumb Screw
Clamp
Inlet
Hose
Hose Cuff
Before performing this procedure, you must first shut off the mower and leaf
and lawn vacuum engines, wait five minutes for all parts to stop and cool, and
disconnect the spark plug wire of the leaf and lawn vacuum.
To Next Page
Loading...
