CONTACT US AT www.DRpower.com 33
Dumping
1. Shut down the Mower and Vacuum Engines and set the Mower Parking
Brake when you are at the Dump area.
2. Pull the Dump Lever while pushing down on the cart bed
(Figure 81).
With the lever pulled, guide the Bed/Collector until the cable is taught
(
Figure 82
).
3. If the collector is empty, it is recommended to hold and guide the bed as
it comes up, if not this action can be startling. If the Collector is full and
doesn’t tip back on its own you can lift up on the front of the Cart.
4. Lift up on the Tube Frame Handle to start emptying the Container and
then release (Figure 82). The Upper Collector will remain raised (Figure
83). You may need to shake the collector to fully loosen the material.
5. Drive the Mower forward with the Collector fully open to move the Leaf
System away from the pile of debris and allow all debris to slide from the
Cart Bed.
6. Pull down on the Tube Frame Handle to close the Enclosure onto the Cart.
Ensure that the Rear Flap is positioned inside the Enclosure.
7. Pull down at the front of the Enclosure, PRO units can also use the foot
assist to help aid in this step. Bring the bed down until the Latch is secured
by the Dump Lever (Figure 84).
• Pull the Enclosure Sleeve around the Outlet Chute (Figure 85).
• Always shut off the tractor engine and the vacuum engine and use caution
when dumping the collector load.
• Never back up with the Cart in the dump position.
To Next Page
Loading...
Need help?
General