34 DR
®
LEAF and LAWN VACUUM
Converting to Cart Trailer Mode
Tools Needed:
• 5/16" Wrench
• Two 3/4" Wrenches
• Flat Head Screwdriver
• Safety Glasses
1. Remove the Rubber Strap from the Hose Support (Figure 86).
2. Disconnect the Hose from the Impeller Housing using a 5/16" Wrench
(Figure 87).
3. Turn the Thumb Screw Clamp to disconnect the Hose from the Deck
Adapter (Figure 88).
4. Unhitch the Cable Link from the Enclosure eyebolt (Figure 89).
5. Pull the Enclosure Sleeve from the Outlet Chute.
6. Remove the Hitch Clip from one end of the Hinge Pin and from the other
end pull the Hinge Pin from the Cart/Enclosure Hinge (Figure 90).
7. Lift the Enclosure from the Cart and set aside. For larger models this is a
good time to have a helper.
Before performing any maintenance, repairs or inspection, you must first shut
off the mower and leaf and lawn vacuum engines, wait five minutes for all
parts to stop and cool, and disconnect the spark plug wire of the leaf and lawn
vacuum.
To Next Page
Loading...
Need help?
General