CONTACT US AT www.DRpower.com 9
b. Pull the recoil starter grip lightly until resistance is felt, then pull briskly.
5. Starting the engine – Electric Start
a. Turn the engine switch to the “START” position and hold it there until the
engine starts.
b. When the engine starts, allow the engine switch to return to the “ON” position.
6. Once the engine is running push the choke lever to the “OPEN” position.
Don’t allow the recoil starter grip to snap back against the engine. Return it gently to prevent damage to the starter
Do not use the starter for more than 5 seconds or starter motor damage may occur. If the engine fails to start, release the switch
and wait 10 seconds before operating the starter again.
Recoil Starter
Grip
Engine Switch
Choke Lever
CLOSE
OPEN
To Next Page
Loading...
