22 DR
®
VERTICAL SHAFT ENGINE
period.
(3)
Any warranted part that is scheduled for r
eplacement as required maintenance in the written instructions must
be warranted for the period of time prior to the first scheduled
replacement point for that part. If the part fails
prior to the first scheduled replacement, the part must be repaired or replaced by Rato according to
Subsection (4) below. Any such part repaired or replaced under warranty must be warranted for the
remainder of the period prior to the first scheduled replacement point for the part.
(4)
Repair or replacement of any warranted part
under the warranty provisions must be performed at no charge to the owner at a warranty station.
(5)
Notwithstanding the provisions of Subsection
(4) above, warranty services or repairs must be provided at distribution centers that are franchised to service
the subject Engine/equipment.
(6)
The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in
fact defective, provided that such diagnostic work is performed at a warranty station.
(7)
Rato is liable for damages to other Engine/equipment components proximately caused by a failure under
warranty of any warranted part.
(8)
Throughout the emissions control system's warranty period set out in subsection (b)(2), Rato must maintain
a supply of warranted parts sufficient to meet the expected demand for such parts and must obtain additional
parts if that supply is exhausted.
(9)
Manufacturer-approved replacement parts that do not increase the exhaust or evaporative emissions of the
Engine or emissions control system must be used in the performance of any warranty maintenance or repairs
and must be provided without charge to the owner. Such use will not reduce the warranty obligations of Rato.
(10)
Add-on or modified parts that are not
exempted by the Air Resources Board may not be used. The use of any non-exempted add-on or modified
parts will be grounds for disallowing a warranty claim. Rato will not be liable to warrant failures of warranted
parts caused by the use of a non-exempted add-on or modified part.
(11)
Rato issuing the warranty shall provide any documents that describe that warranty procedures or policies
within five working days of request by the Executive Officer.
(d)
Emission Warranty Parts List for Exhaust
(1)
Fuel Metering System
(i)
Carburetor and internal parts (and/or pressure regulator or fuel injection system).
(ii)
Air/fuel ratio feedback and control system.
(iii)
Cold start enrichment system.
(2)
Air Induction System
(i)
Controlled hot air intake system.
(ii)
Intake manifold.
(iii)
Air filter.
(3)
Ignition System
(i)
Spark Plugs.
(ii)
Magneto or electronic ignition system.
(iii)
Spark advance/retard system.
(4)
Exhaust Gas Recirculation (EGR) System
(i)
EGR valve body, and carburetor spacer if applicable.
(ii)
EGR rate feedback and control system.
(5)
Air Injection System
(i)
Air pump or pulse valve.
(ii)
Valves affecting distribution of flow.
(iii)
Distribution manifold.
(6)
Catalyst or Thermal Reactor System
(i)
Catalytic converter.
(ii)
Thermal reactor.
(iii)
Exhaust manifold.
(7)
Particulate Controls
(i)
Traps, filters, precipitators, and any other device used to capture particulate emissions.
To Next Page
Loading...
Need help?
General
