Need help?Do you have a question about the Dräger Medical Titus and is the answer not in the manual?
General| Category | Medical Equipment |
|---|---|
| Manufacturer | Dräger Medical |
| Model | Titus |
| Type | Anesthesia Machine |
| Power Supply | 100 – 240 VAC, 50/60 Hz |
| Gas Supply | O2, N2O, Air |
| Ventilation Modes | SIMV |
| PEEP | 0-20 cmH2O |
| Oxygen Concentration | 21-100% |
| Vaporizer Mounts | Up to 2 |
| Monitoring | oxygen concentration |
| Display | Color screen |
Emphasizes understanding and adhering to the manual for safe operation.
Advises on handling the machine during assembly and avoiding excessive tilting.
Explains how to connect the machine to gas sources, including recommendations for 'Air'.
Details connecting to a central supply system or using gas cylinders.
Describes gas supply from a portable cylinder pack for mobile and emergency use.
Guides on assembling the circle system, including CO2 absorber and valves.
Explains how to supply Ventilog with compressed gas, including placement and safety warnings.
Details how to attach the plug-in vaporiser to the anaesthetic machine.
Details the installation of sensors for volume, pressure, and O2 measurement.
Explains how to connect monitors for CO2 and anaesthetic gas concentration.
Guides on connecting the Magill inhalation device for emergency use.
Outlines critical safety measures for operating the device in an MRI environment.
Explains how to prepare and use the plastic checklist for pre-use checks.
Stresses the importance of performing checks before every use and how to record them.
Outlines prerequisites and tests for the gas supply, flowmeters, and S-ORC function.
Provides steps to rectify gas supply disruptions or manage failures.
Provides a comprehensive list of components and their required cleaning/sterilization intervals.
Lists intervals for apparatus inspection, safety checks, and component replacement by experts.
Details how to test the O2 shortage alarm and N2O cut-out mechanism.
Explains how to test the S-ORC's function in limiting N2O flow based on O2 concentration.
Explains how to perform a leak test on the low-pressure system with and without the Vapor.
Describes safety features like O2 shortage alarms and the O2 ratio controller (S-ORC).
To Next Page
