GB
WARNING
A cracked cable may cause serious injury and
even the death of people in its way.
Do not cross over a stretched cable and never
stand over the cable.
The vertical pull winch should only be used for the pur-
poses for which it was designed - helping to get vehicles,
cargo or objects out from a difcult position. The use of a
winch for other purposes is inconsistent with its intended
use and may result in death, injury and property damage.
Use only genuine spare parts. If they are not available, use
parts with appropriate approvals and safety certications.
Do not overload the winch. Winch capacity specications
are maximum parameters, not working parameters.
Remember that the winch pull force values are specied
for the rst fake of the cable on the drum and for perfect
conditions. Any obstacle (slope, mud, water, marshy ter-
rain, etc.) signicantly reduces the winch pull force.
Any jerks while pulling are very dan-
gerous and may lead to breaking the
cable, damaging the winch as well as
serious injuries. Although, the term
“vertical pull” is mentioned in the de-
scription of the winch capacity, under
no circumstances may the winch be
used for vertical load lifting. Both the
winch and the cable are not designed for such use. The
term “vertical pull” only serves to determine the capacity
and the technical parameters of the winch.
If the motor has heated up too much, stop working for
a few minutes – until it cools down.
If the motor stops, disconnect the power supply and diag-
nose the problem.
Overloading the winch may also cause cable damage.
Avoid accidentally activating the
winch by disconnecting it mechani-
cally from the power supply.
When the winch is not in use, switch
the gear transmission lever to “OUT”
or “LUZ.”
To Next Page
Loading...
