Step 1: Place vehicle on a at and level surface. Place gear selector in “Park” and remove keys from the ignition.
Step 2: With the 4mm Allen wrench, remove 2 bolts on the side from the mount of the Sport Side Mirror [P1 or P2] (Figure A). Set the bolts and
clamp band aside for next step.
Step 3: Place mirror and clamp band onto the frame of the vehicle at the desired location (Figure B). Loosely tighten the 2 bolts removed in
Step 2.
Step 4: Place a Rubber Pad Insert [P3] where shown (Figure C).
Step 5: Position the mirror at the desired height. While holding rubber pad in place, tighten middle bolt (shown by arrow) until clamp is secured
(Figure D).
Step 6: Rotate mirror to desired position on the frame and then tighten the 2 bolts on the side until secured (Figure E).
Step 7: Loosen the middle bolt just enough to rotate mirror on the clamp. Do Not uninstall bolt completely. Adjust mirror to desired position and
then tighten the middle bolt until secured (Figure F).
Step 8: When mirror is at the desired height and viewing angle, check to ensure all bolts are
securely tightened (Figure G). Repeat installation instructions for opposite side Sport
Side Mirror.
Step 9: This completes installation. Time to ride and enjoy!
ProTip: Periodically check all hardware and re-tighten if needed.
DragonFire Racing puts everything within reach.
Learn more about powersports frame & body we have.
To Previous Page
Loading...